Comet Caliente body

[Mastercaster]

     

OK....The mold for this is done.  I added brass rod in the posts.  These become a permanent part of the mold.  You will not want to lose these.  You can put a thin film of silicone grease on them or spray mold release on them before pouring the resin to make the body.  Once the body is removed from the mold, use a pliers to twist and remove the rod from the cured body.  Put the rods back in their holes in the same direction.  Scratch marks from pliers will make the difficult to remove.

[Mastercaster]

Here is the first body.

[Excrewchief]

That is looking nice.
Now for the rest of the parts. It never ends

[gothic]

Nice work.